← All guides

Rufus troubleshooting: common errors and fixes

Last updated:

Most Rufus errors come from one of three things: a damaged ISO file, a failing or badly connected USB drive, or security software blocking access to the drive. Work through the section that matches your problem.

First, open the log

Rufus keeps a detailed log of everything it does. Press Ctrl+L, or click the log icon at the bottom of the window, and read the last few lines after a failure. They usually name the exact step that failed, which tells you which section below applies.

Rufus doesn't show my USB drive

If the "Device" list is empty or your drive is missing, check these in order:

  • External hard drives and SSDs in USB enclosures are hidden by default so they are not erased by mistake. Open "Show advanced drive properties" and tick "List USB Hard Drives".
  • Plug the drive directly into a port on the PC, not into a hub or a front-panel extension, and try a second port.
  • Open Windows Disk Management. If the drive is missing there too, the drive, the cable or the port is at fault, not Rufus.

"ISO image extraction failure"

Rufus could not copy every file from the ISO to the drive. The usual causes, most likely first:

  • The ISO download is incomplete or damaged. Click the checkmark button next to "SELECT" to compute its SHA-256, compare it with the value published by the ISO's maker, and download the ISO again if they differ.
  • The USB drive is failing or reports a false capacity. Try another drive, or run "Check device for bad blocks" under "Show advanced format options".
  • Security software interrupted the copy. In Windows Security, add Rufus to the apps allowed through "Controlled folder access", or turn that feature off while you write the drive.

"Access to the device is denied"

Another program is holding the drive, or Windows is blocking Rufus from writing to it.

  • Close File Explorer windows and any program that has files open on the drive, then press "START" again.
  • Allow Rufus through "Controlled folder access" in Windows Security, or pause your antivirus while Rufus runs.
  • Unplug the drive, plug it into a different port and try again.

"Undetermined error while formatting"

This message almost always points at the hardware. Move the drive to another port, preferably one directly on the motherboard, and avoid hubs. If it fails again, untick "Quick format" and enable "Check device for bad blocks" to test the drive. A drive that fails this test is worn out or counterfeit and should be replaced.

"The media is write-protected"

Check the drive and any SD card adapter for a physical lock switch. If there is none, the drive's controller has put it in read-only mode, which flash drives do when they reach the end of their life. Software cannot undo that; copy off what you can and replace the drive.

The drive was written but the PC won't boot from it

  • Open the PC's boot menu at power-on (usually F12, F11, F8 or Esc) and choose the USB drive. Many PCs do not try USB first on their own.
  • Match the partition scheme to the PC. Use "GPT" with "UEFI (non CSM)" for PCs from the last decade, and "MBR" with "BIOS (or UEFI-CSM)" for older machines. Rewrite the drive if you chose the wrong one.
  • Some Linux and utility images are not signed for Secure Boot. Turn Secure Boot off in the firmware settings to start them, and turn it back on afterwards.
  • On an older PC, try a USB 2.0 port. Some firmware cannot boot from USB 3 ports.

Getting the drive back to normal

To use the drive for ordinary files again, select it in Rufus, set "Boot selection" to "Non bootable", choose FAT32 or exFAT as the file system and press "START". This removes the bootable layout and restores the full capacity.

Download Rufus 4.16 →

← All guides